Caldera Paradise Series - Manual (Page 10)

OPERATION - CONTROL PANEL
Page 8
Liquid Crystal Display (LCD) Mode touch pad Selects standard
or economy operating mode
SPA-SIDE CONTROL OPERATION
Your spa-side control system consists of an illuminated
Liquid Crystal Display (LCD) and convenient touch pads
that allow you to set the water temperature and adjust the
skim/filter cycle settings, as well as control the hydrotherapy
jets, mood light and optional air jets from spa side.
LIQUID CRYSTAL DISPLAY (LCD) The LCD continually
displays the current water temperature. In certain situations,
other messages will appear. See page 19 for descriptions.
TEMPERATURE To display the set temperature for
three seconds, press either WARM or COOL. To
change the set temperature, while the set tempera-
ture is displayed, press WARM to increase or
COOL to decrease the set temperature.
Pressing the Hydro Jets 1 touch pad sequences
the operation of the dual-speed pump as follows:
1. Low speed on.
2. High speed on.
3. Pump off (except during automatic functions).
Pressing the HYDRO JETS 2 touch pad turns
the single speed pump on and off.
The pumps automatically turn off after operating for 15
minutes.
Press the AIR JETS touch pad to start or stop
the air jets. The air jets operate for 15 min-
utes, then automatically shut off.
The LIGHT touch pad allows you to select from
three different settings. Press the Light touch
pad once to turn on the brightest setting. Press
a second time to turn on the intermediate setting, and
again for the dimmest setting. Press the touch pad a
fourth time to turn off the light. The light automatically
turns off after 4 hours of operation.
The MODE touch pad switches between the
standard and economy operating modes.
Hydro Jet pump 1 and 2 will operate automatically
whenever a filter cycle is activated or when a poten-
tial freezing condition is detected. If automatically
activated, the pumps cannot be turned off with the
Hydro Jet touch pads.
DISPLAY INVERSION You may invert the main,
four-digit display for easier viewing from inside the
spa. Press either OR , then with-
in three seconds.
WARM (up) touch pad
Increases the temperature
LIGHT touch pad
Controls the 3-way Mood Light
HYDRO JETS touch pads
Controls Hydro Jet pumps 1 and 2
AIR JETS touch pad
Controls the Air Jets
COOL (down) touch pad
Decreases the temperature
setting
Warm Time
Cool Hydro Jets Air Jets
Light
Warm Time
Cool Hydro Jets Air Jets
Light
Warm Time
Cool Hydro Jets Air Jets
Light
Warm arm Time
Cool Hydro Jets Air Jets
Light
Warm Time
Cool Cool Hydro Jets Air Jets
Light
Warm Time
Cool Hydro Jets Air Jets
Light Light
Warm Time
Cool Hydro Jets Air Jets
Light
Hydro Jets 1 Hydro Jets 1
Hydro Jets 2
Hydro Jets 1
Hydro Jets 2 Hydro Jets 2
Air Jets Air Jets
(Option) (Option)
Liquid Crystal Display (LCD)
Mode touch pad Selects standard
or economy operating mode
WARM (up) touch pad
Increases the temperature
LIGHT touch pad
Controls the 3-way Mood Light
HYDRO JETS touch pad
Controls the Hydro Jet pump
AIR JETS touch pad
Controls the Air Jets
(Martinique only)
COOL (down) touch pad
Decreases the temperature
setting
Geneva • Niagara • Tahitian • Hawaiian
Martinique • Kauai