Panasonic TX-56P800H - Manual (Page 11)

29-OCT-2004 13:13 FROM
TO opgrating instr P.ll
General Operation
SOUWD
SET UP
TV/TEXT,
100Hz/
SURROUND
1
ASPECT
Power (Stand-by) (see page 6)
The TV set must first be plugged into the wall
outlet and turned on at the power switch.
Press this button to turn the TV set On from
Standby mode, press it again to turn the TV set
OFF to Standby mode.
Note:
* It is also possible to turn the TV set on from STANDBY
mode by pressing the “Direct Programme Number
Selection" Buttons (0-9) and the “Programme Number
Up or Down" Button, either on the set or on the
Remote Control.
Sound Mute
Press to mute the sound completely the “Mute” symbol will appear.
Press again to restore the previous sound level, and cancel the mute.
f- Volume Adjustment
Press to increase or decrease the sound
voiume level.
V
(©if
9 0 0 0
\ f . p .
©
INDEX
©
: h searci
HOLD
Q
1 STILL
Programme Number Selection
Press to select the next higher or
lower Programme number.
lU (Al (U
CO | 8J ID
(3
TEXT Index (see page 32)
TEXT hold (see page 31)
/Still (see page 29)
VCR/DVD Play
VCR/DVD
Fast Forward/cue
VCR/DVD Stop
VCR/DVD Control
($ee page 33)
Help (see page 12)
(VOLUME
Coloured buttons used for
Multi Screen functions
(see page 29)
Teletext functions (see page 30)
AV selection (see page 11)
■ TV/AV Mode Selection
Press to select TV, AVI, AV2, AV3 and
AV4 input signal modes sequentially.
Remote control : TV/AV
AVI AV2 r AV3 AV4
Press to display AV1 - AV4 at the
bottom of the screen. Each coloured
button
corresponds to each input
signals. For example, pressing the Red
button selects AVI,
Direct programme Number
’ Direct Programme Number Selection
(CH SELECT = DIRECT)
You can select the number directly by
pressing the corresponding programme
number buttons.
Programme Numbers......
P' ^■‘'imme Number 36... 1^, (j]
'‘¡on
Cr is ÍÍ
RETURN
NVEfiGENCE:!.;
■"•:¡Í*7 a ""'’SELECT '
TV^AVit-éíITí
13