Panasonic TX-56P800H - Manual (Page 21)

29-OCT-2004 13:14 FROM
Tuning Charioeis
TO opgrating instr P.21
How to Caiieel the Skip Foriction
1 Press to select the SKIP.
— Press to change the mode to “OFP’'
2
--------- Press to store the Skip function.
Sound System Selection (Different region use differing systems)
This function is used only in the TV mode when the sound is not clear or no sound is produced on a Programme Number, and is not
applicable in AV mode .
“ Press to select the “SOUND SYS".
— Press until the optimum sound is obtained.
The sound system will change as shown.
- 4.5MHz ^------ > 5.5MHz
- 6.5MHz
^----- > 5.5MHz ^
''i-----^ 6,0MHz ^
Sound System
Condition.
Note:
These are different sound broadcast transmission systems applicable to differing countries.
STR
CT-
TV/AV
c-
Press to store the Sound System.
Press to exit from the “SOUND SYS".
This returns the set to the normal viewing condition.
Colour System Selection (Different region use differing systems)
a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, this function is used.
Press to select the “COLOUR SYS".
Press to produce the optimum image.
A.
The colour system will change as shown.
C AUTO PAL-^^ SECAM
NTSC3.56^i------- ^ NTSC4.43^
Note:
PAL, SECAM and NTSC 3.5B are different colour signal broadcast transmission systems applicable to differing countries. NTSC
4.43 is a trick playback mode used in special VCR to playback NTSC recorded video tapes through PAL television equipment.
STR
G-
TV/AV
O-
Press to store the Colour System.
Press to exit from the “COLOUR SYS".
This returns the set to the normal viewing condition.
91