Panasonic SC-CH84M - Manual (Page 36)

tJdng the r€card timer
0REC/
©PLAY
7 STAye|Y^N
(T POWW Vi
Prepare for recording.
1. Insert a tape into deck 2 with the for­
ward side facing you.
2. Select the appropriate Dolby noise-
reduction system.
3. Select the reverse mode.
4. Select which direction the tape runs
in.
Press EQ SPACE to select "FLAT. 5.
Select the desired source and
then prepare for recording.
When you record from the radio:
Press TUNER BAND to select the de­
sired band and tune in the desired
station.
When you record from a unit con­
nected to the "AUX” terminals:
Press AUX.
Press © REC/© PLAY.
Your selections and setting will be stored
in the timer’s memory.
Please confirm “© REC" lights on the
display.
Press POWER to put your ste­
reo on standby.
Sound will be automatically muted
roughly 30 seconds prior to the set time
and recording will start.
To check settings (only while power is ON)
Press CLOCiVTlMER two times and check “© REC” is displayed.
Two seconds later, the display will change in the following order.
® Recording start time
d) Recording over time
@ Recording source
To change settings (only while power Is ON)
( 1 ) Press ©REC/® PLAY and check “© REC" goes out.
d) Reprogram from step 1.
To switch the timer OFF
Press © REC/© PLAY and check "© REC" goes out.
The settings made with the preceding procedure will however be kept
in memory.
Using the timer at the same time setting continu­
ously
{You can accomplish this even if your stereo is on standby.)
Press ® REC/® PLAY and check “® REC" is displayed.
To enjoy the desired source after the timer setting
is completed
1, After finishing step 7, switch on the power, and start playing the
desired source.
When listening to a cassette tape, use deck 1.
Even if you change the music source, the timer recording will start
with the preset condition.
2. Press POWER to set the stereo on standby after enjoying play,
and confirm a tape is inserted in deck 2.
• If the power is on, the timer will not function.
•The ON time and OFF time cannot be the same setting.
• If you switch the power to the standby mode while the record timer
is ftjnctioning, the OFF time setting will not be activated.
• Play timer cannot be used in combination with a record timer.
For your reference
•Set recording to start roughly two minutes ahead of time.
• External sources must be connected to the “AUX” terminal. How­
ever, time settings apply only to tills stereo. For more information,
see the instruction manual of the connected unit.
36