Panasonic SC-AK57 - Manual (Page 15)

Listening to radio broadcasts
f ~ it'/
> f I
p ~ f о n
О i . ^ i u
¿ TUNE MODE n n l~ r~ г T
г гг л _Н н_ '
/t '/ /”? it / / / o /
M / f / t/ U M í_
Ш
VOLUME
DOWN -dB OdB
FM MODE/BP
:
I //)”//
; f' и и
„ Í / n J T( \
t U i-/ 2J ;
! TUNED '
; MONO
Press [TUNER/BAND] to select band.
The unit comes on and the radio begins to play.
Every time you press the button; “FM”t—»■“AM''.
Press [■, TUNE MODE] to select “PRESET’ or
“MANUAL”.
Every time you press the button: “MANUAL"«—>“PRESET”,
PRESET: For preset stations
MANUAL: For non-preset stations
Press [TUNE/TIME ADJ ( v or a ) ] to select the
desired broadcast.
"STEREO” lights when an FM stereo broadcast is being re­
ceived. “TUNED" lights when you precisely tune in a broadcast
station.
Turn [VOLUME] to adjust the volume level.
Auto tuning
Auto tuning is an easy way to tune in non-preset stations in the
manual mode.
Hold down [TUNE/TIME ADJ (v or a )], and release the button
when the frequency starts scrolling.
The radio will stop automatically on the first station it picks up.
•When there is outside interference, the radio sometimes stops on
a certain frequency where no station is broadcasting.
To stop auto tuning
Press [TUNE/TIME ADJ (v or a )] again.
If noise is excessive in the FM stereo mode El
Press FM MODE/BP]. (“MONO” will light up.)
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. “MONO" will go out.
Normally, you'll want to listen in stereo, so leave “MONO" off. This
way, you can listen to stereo broadcasts in stereo, and monaural
broadcasts in mono.
You can preset an FM station in monaural by following the steps
under “Presetting only your favorite stations" on page 26, After se­
lecting the station in step 1, select “MONO" with FM
MODE/BP], then continue with steps 2 and 3.
• If you preset stations in memory they can be easily selected from
the remote control with [►/11/л] or the numeric buttons.
1, Press [TUNER] to select the band.
2. Press [◄/v] or [►/H/ a ] to select the channel, or select the re­
quired channel directly with the numeric buttons.
To select a two-digit channel;
Press [510] and then the two numbers you want within 10 sec­
onds or so.
• Sound is momentarily interrupted if you load/unload tapes while
listening to an AM broadcast.