Yamaha CLP-970AM - Manual (Page 96)

CLP-970A/970AM/970AC:
Keyboard Stand Assembly
A CAUTION
■ Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor­
dance with the sequence given below.
Assembly should be carried out by at least two persons.
Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
Be sure to tighten up all screws upon completing assembly of each unit.
To disassemble, reverse the assembly sequence given below.
1
.
Attach the side panels to the pedal box.
Place the plastic bag that contained the side
panels on the floor when assembling the stand
to prevent scratches to the floor or stand.
Make sure the
The parts shown in the “Assembly Parts" illustra-
i n dent
.
f d surf a ce on
.
the side panel and the
tion will be used. Follow the assembly instructions
rear surface on the
and select the parts as needed.
pedal box will match
side pane^ II correctly, without
Assembly Parts
(rights '
11
I ' creating a step.
(2) Use the four long
round-head
screws O to
attach the pedal
box. First attach
one side panel,
then attach the
other side panel.
side panel
(left)
(1) Untie and straighten out the
bundled cord attached to the
bottom of the pedal box.
Don't discard the vinyl tie,
you'll need it later in step 6.
2
.
Attach the rear panel.
main unit
pedal box
I ( J U l i
Bundled pedal cord inside AC pow ® r cord
(2) Secure the top of the
rear panel to the side
panel brackets using
two thin round-head
screws 0.
(1) With the rear
panel on the
feet's
protruding
edge, align the
panel with the
groove and
secure the top
of the panel.
(3) Secure the
bottom of the
rear panel to the
pedal box using
four tapping
screws O.
96
CLP-970A