Cobalt Networks OPENGEAR PS-8300 - Manual (Page 10)

Page 10 of 40 8310 User Manual
••••
(V 1.0.1)
Robust Power Supplies
The 8310 frame can accommodate two front-loaded PS-8300 power supplies. Although a single power
supply can fully power a loaded frame, the addition of a second (optional) power supply gives the
frame full power redundancy. Each power supply is fed by a separate power cord, which is held in
position to guard against accidental power loss.
Each power supply contains an independent cooling fan, status LED, and a front-mounted power
switch.
Each frame comes standard with one PS-8300 power supply.
Optional Cooling Fans
The frame has been designed with an advanced cooling architecture to increase ventilation.
For applications where the total card load is less than 40 Watt, the 8310 can be used without cooling
fans. Frames should be mounted with 1RU empty space between frames.
For applications where frames are mounted directly above or below other equipment, or where the total
card power load is greater than 40 Watt, an optional cooling fan kit must be added. These front-door
mounted fans provide forced air cooling for all cards, and additional cooling for the power supplies. An
intelligent fan controller adjusts fan speed with changes in frame power loading. Particular attention
has been paid to frame acoustics in order to keep fan noise to a minimum.
Additional Frame Accessories
To help reduce mechanical stress due to cable weight, a rear frame support bracket (FSB-8310) is also
available.
openGear TM Cards
The 8310 will accommodate any openGear TM 8200 series cards.
Important For long-term reliability and increased product lifespan, total
dissipation of all cards installed in a 2RU frame must not
exceed 40 Watt total without the use of the Cooling Fan
Module. Refer to the section, “Ventilation and Cooling,” in
this manual, for details.
Features
The following features make the 8310 frame the best solution for standard and high definition terminal
equipment:
•
2RU Frame houses up to 10 cards
•
Can house any mix of analog, digital, video and audio cards in the same frame
•
Available with fixed 100-BNC rear module, or individual card specific modules for
connector flexibility
•
Heavy-duty hinged front panel lowers to allow easy card insertion
•
Durable powder-coat paint finish
•
Aluminum construction reduces overall weight
•
Two independent looping Reference Inputs feed all card slots
•
SMPTE alarm interface for simple monitoring
•
Ethernet port for optional networked control