Yamaha HTR-5860 User Manual
Page 90
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING
Problem
Cause
Remedy
Referto
page
The sound suddenly
goes off.
The protection circuitry has l^een activated
because ot a short circuit, etc.
Check that the impedance selector setting is correct.
73
Check that the speaker wires are nol touching each
oilier and Ihcn turn this unit back on.
—
The sleep timer has turned the unit off.
Turn on Ihe powder, and play the source again.
—
The sound is muted.
Press MUTE to cancel a mute.
31
Only the speaker on
one side can be
heard.
Incorrect cable connections.
Connect the cables properly. If the problem persists,
the cables may be defective.
12
Incorrect balance settings in SET MENU. Adjust the SPEAKER LEVEL settings.
65
Only the center
speaker outputs
substantial sound.
When playing a monaural source with a
CINEMA DSP program, the source signal
is directed to the center channel, and the
i'ronl and surround speakers output effect
sounds.
________
No sound from the
effect speakers.
The sound field programs are turned off
Press STR.AIGFIT (EFFECT) lo Uirn them on.
35
You are using a source or program
combination that does not output sound
from all channels.
Try another sound field program.
55
No sound from the
center speaker.
The output level of the center speaker is
set to minimum.
Raise the level of the center speaker.
65
"CENTER SP" in SET MENU is scl to
NONE.
Select the appropriate setting for the center speaker.
63
One of the HlFi DSP programs (except for
7ch Stereo) hits been selected.
TrV' another sound field program.
55
No sound from the
surround speakers.
The output level of the surround speakers
is set to minimum.
Raise Ihe output level of the surround speakers.
65
“SlIR. L/R SP” in SET MENU is set to
NONE.
Select Ihc appropriate setting for the surroiiiid left and
right speakers.
63
A monaural source is being played with
STRAIGHT. ^ "
Press STRAIGHT (EFFECT) lo turn on Ihc sound
fields.
—
No sound from the
surround back
speakers.
Surround back speakers are not selected.
Select surround back speakers in SUR. B L/R SP.
64
“SLIR. L/R SP” in SET MENU is set to
NONE.
If Ihc suiTound left and right speakers are set lo
NONE, Ihe surround back speaker setting is
automatieally set lo NONE. Select the appropriate
setting for the surround speakers.
63
“SLIR. B L/R SP” in SET MENU is set to
NONE.
Select LRGxI orSMLxl.
64
No sound from the
subwoofer.
“LFE/BASS OUT” in SET MENU is set
to FRNT when a Dolby Digitiil or DTS
signal is being played.
Seleel SWFR or BOTH.
64
"LFE/BASS OUT” in SET MENU is set
to SWER or FRNT when ;t 2-channel
source is being played.
Scleci BOTH.
64
The source does not contain low bass
signals.
^ ------------------------------------------
86