Panasonic CY-V7100U - Manual (Page 27)

Installation
WARNING
□ This installation information is designed for professional installers with knowledge of
automobile electrical safety systems and is not intended for non-technical, do-it-
yourself individuals. It does not contain instructions on the electrical installation and
avoidance of potential harm to air bag, anti-theft and ABS braking or other systems
necessary to install this product.
Any attempt to install this product in a motor vehicle by anyone other than a profes­
sional installer could cause damage to the electrical safety system and could result
in serious personal injury or death.
□ If your car is equipped with air bag and/or anti-theft systems, specific procedures
may be required for connection and disconnection of the battery to install this prod­
uct.
Before attempting installation of this electronic component against the manufacturer’s
recommendation, you must contact your car dealer or manufacturer to determine the
required procedure and strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOYMENT
OF AIR BAGS OR ACTIVATION OF THE ANTI-THEFT SYSTEM RESULTING IN DAMAGE TO
THE VEHICLE AND PERSONAL INJURY OR DEATH.
□ Overview
This product should be installed by a professional.
However, should you decide to install the product against
the manufacturer’s recommendation, this Operating
Instructions does not contain electrical installation instruc­
tions. You must contact your car dealer or manufacturer
for electrical connection instructions to avoid possible
damage to your electrical safety systems and resulting
injury. (Please refer to the “WARNING” statement
above).
Your next step is to decide where to install the unit. The
instructions in these pages will guide you through the
remaining steps
• Identify and label the car wires.
• Connect the car wires to the wires of the power connec­
tor.
® Install the unit.
• Check the operation of the unit.
If you encounter problems, please consult your nearest
professional installer.
□ Supplied Hardware
No. Item Diagram Qty
© Junction Cable 1
© Power Lead 1
© Mounting Tray 1
© Trim Plate 1
©
Tapping Screw
(0 2.6 X 16 mm)
4
Binding-Head Screw
(M 5
X 6 mm) *iS
4
©
Tapping Screw
(0 5 x 1 6 m m )
4
© Mounting Bracket 2
Before you begin installation, look for the following items
which are packed with your unit.
Caution: Thss operates with 312 V DC negative
gtound auto battery system ociy. Do not attempt to use
d id any Gtbc-r system Doing so oouìd cause sonoss
tilÉSipt 1 -
• Warranty Card.... Fill this out promptly.
a Panasonic Servicenter for Service Directory ......
Keep for future reference in case the product needs
servicing.
• Supplied Hardware... Needed for installation.
CY-V7100U
2 7