Panasonic CY-V7100U - Manual (Page 35)

Lay the cable.
Lay the junction cable ® along the seat while pulling the
cable slightly to prevent slack.
Secure the cable firmly with optional cord clamp or other
items.
Secure the cable with
optional cord clamp or
other items.
Cautior?: Tbs iurrction саЫв ‘ should Ы secured not to
imerfere wrth drivef’s operation. In atìdftion. ft shodW be
noted that the eabte cioes not interfere with the motion ot tne
brake pedal, the air bag. etc.
ЯЙ!
©Tapping Screw
Secure the hide-away unit.
Drill for 4.8 mm diameter holes to the chassis.
Apply an anticorrosive to the holes and tapping screws.
Make cuts by using cutter on the carpet.
Attach the mounting brackets ® on both sides of the unit
with the binding-head screws ®.
Attach the seal side ot the velcro tape (option) to the hide­
away unit, then mount the unit on the carpet.
Install the unit with tapping screws @.
Connect the junction cable ® after the installation.
® Binding-Head
Screw
Binding-Head
Screw
® Mounting
Bracket
Mounting Bracket
Cautions:
* Never fflouftl Ihe uriii irr .im of the foiiovrtftg iocations to avoid damage sue to overheating;
1, Near the beater port.
2. Places like the mar deck, where it may be exposed to direct synliriht,
¡¡11Д11|||||дД1||1||М||||1д||я|111(|Д|1|||1||1Дм
» You run the risk of Interferltig wfth the moufltiiig or causing damage by drilling roto the gas tank, a wiring harness, or
other compor?eot
To Remove the Trim Plate
Insert a screwdriver between the mounting tray @ and the surface material of
the headrest.
Push ail the hooks (6 pieces) of the trim plate @ inside in turn with the tip ot the
screwdriver.
CY.V7100U
3 5