Recording from a tv broadcast signal – Panasonic NV-FS1 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECORDING FROM A TV BROADCAST SIGNAL
REW.' E3~
•O/FF
PAUSE.'STILL
«I
t»
DU I
0
Preparation
•Make sure that the Timer Record Function is set to “Off”,
•Reset the Tape Counter to “0:00.00".
•Insert a video cassette with the erasure prevention tab
intact.
When a video cassette is already inside the VTR, press
the VTR On/Off Switch to turn it on.
•Set the Input Signal Selector to “Tuner".
•Set the Audio Rec Level Control Selector to “AGC".
•Set the Tape Speed Selector to “SP” or “LP”.
•Press the VTR/TV Selector to “VTR” position.
^ Select on the VTR, the programme position (channel)
to be recorded. In order to confirm proper reception,
turn on the TV set and select the video playback
channel.
^
0 Set the S-VHS Selector to “AUTO”.
AUTO: S-VHS cassette tape are automatically re
corded in the S-VHS format and VHS casset
te tapes are automatically recorded in the
VHS format.
OFF:
To make a recording in the VHS format on an
S-VHS cassette tape.
0 Press the Record Button (•).
R E C #
REC
When a video cassette with broken out tab is inserted,
it will be ejected automatically.
•During recording, the programme position (channel)
on the VTR cannot be changed.
•To start a recording with the Remote Controller, press
the two Record Buttons on the Remote Controller
simultaneously.
To Finish the Recording
O Press the Stop Button
(I
If You Wish to Avoid Recording Unwanted Material
0
Press the Pause/Still Button (
11
) to stop the tape
temporarily.
PAUSE/STILL
REC
DD
• Press the Pause/Still Button (II) again to continue
the recording.
•If you leave the VTR in the pause mode for more than
5 minutes, the VTR will automatically switch over to
the stop mode to protect the tape and the video
heads.
Recording One TV Programme While Watching
Another
1. Record (following steps 0~©)-
2. Press the VTR/TV Selector to “TV” position.
3. Select the desired programme position (channel) on
your TV set.
•If the Stop Button is pressed to stop a recording,
there may be a small gap between the previous
recording and the subsequent recording on the
same tape.