Problem solving, Problemsolving -1, Hapter – Panasonic Panafax UF-311 User Manual
Page 57
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
:hapter
7,
PROBLEM SOLVING
7
.
1
.
PROBLEM SOLVING
If You Have Any of These
Problems
During Installation
Problem
During Transmission
Problems
Transmission
Copy Quality Problems
During Reception
Problems
Symptom
Action
The display is blinking
Battery discharged completely. May happen at first
installation. After setting the clock, blinking wilt stop.
Document Doesn't Feed/
Multiple Feed
1. Check that your document is free of staples and
paper dips and that it is not greasy or torn.
2.
Check that your document is the right type to send
through a fax machine by consulting the list on
"Documents You Cannot Send", page 4-1. If your
document has the characteristics listed, make a
photocopy of your document and send the copy
instead.
3. Check that the document is loaded properly. See
page 4-2.
4. Adjust the ADF Pressure Plate, see page 7-12.
Document Jam
The information code 031 will appear on the display if
the document becomes jammed. To clear the jam, see
page 7-7.
Vertical Lines on the
Transmitted Document
Check own copy quality. If copy is OK, your machine
has no problem, report to receiving party that they
have a problem. If copy is NG, Clean the Scanning
Plate and Glass, see page 7-8.
Transmitted document
is Blank
1. Make sure the document is set face down.
2. Check own copy quality. If copy is OK, your machine
has no problem, report to receiving party that they
have a problem.
No Recording Paper
The information code 010 will appear on the display if
the paper runs out. To load the paper, see page 2-7.
Recording Paper Jam
The information code Opi or 002 will appear on the
display if the paper gets jammed. To clear the jam, see
page 7-6.
Recording Paper doesn't
Advance into machine
1. Make sure that there is paper in the Paper Supply
Tray. Follow instructions for loading paper, see
page 2-7.
2. Make sure that there is enough paper in the Paper
SupptyTray.
3. Make sure that the paper tray extender is holding
the paper against the machine, see page 2-7.
4. Make sure that paper is loaded squarely in the
Paper Supply Tray, with the right side of the paper
flush against the right side of the Paper Supply
Tray. And also paper width lever is set at the proper
paper size position, see page 2-7.
Recording paper doesn't
eject after printing
1. Make sure that the printing process has completed.
Printing time may be slower than receiving time.
2. Check to see if the recording pa per jammed inside
of the machine.
7 - 1