Measuring your blood pressure – Panasonic EW3006 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Measuring Your Blood Pressure
Fig. 6-a
On/Off
I]
Fig. 6-c
Fig. 6-d
SYS. I
mmHg I
DIA.
mmHg
8?
Pulse
n p
/min. A it
Relax during measurements.
1. Place the storage case under your arm. (Please see
correct position for measurement on pages 12-14.)
2. Press the On/Off and Start button (Fig. 6-a).
• Everything on the display will be shown for approx. 2
seconds, apart from the battery symbol (Fig. 6-b).
• The cuff will begin to inflate automatically.
Fig. 6-e
Changing inflation speeds and operating sounds
occur during inflation and are a normal part of the
measurements that are being performed at this time.
• Once your pulse rate is detected, the V mark will flash
on the display (Fig. 6-c).
3. Blood pressure values together with pulse rate are
displayed when the measurement Is complete (Fig. 6-d).
• The air in the pressure cuff is released automatically.
• Displayed readings will flash (for approx. 6 seconds)
when in the high blood pressure range.
• The (E) mark will flash on the screen to Indicate that
readings may be recorded.
(See page 20 for Information on how to record blood
pressure readings.)
• The displayed pulse rate indicates the number of
heartbeats per minute as calculated from the number
of heartbeats recorded during the measurement.
4. Press the On/Off and Start button to switch off the unit
(Fig. 6-e).
• If you forget to switch the unit off. It will do so
automatically after approx. 5 minutes.
On/Off
Snrt_
15