Panasonic SA-HD52 - Manual (Page 12)

Front Panel Controls and Functions
(COTitinued)
Cassette deck section
О Cassette holder
0 Dolby noise-reduction switch (DOLBY NR)
This switch can t>e used to reduce the amount of the charac­
teristic "hissing” noise heard from the tape.
(Refer to page 21.)
О Reverse-mode selector (REVERSE MODE)
This selector is used for the selection of the desire reverse
mode for recording or playback.
О Tape deck 2 counter/reset button
(DECK 2 COUNTER/RESET)
This tape counter shows the amount of tape movement of the
tape in deck 2.
The reset button can be used to reset the tape counter reading
to “000”.
Note:
To reset the tape counter, be sure to press the reset button
completely. Otherwise, the tape counter may not operate cor­
rectly.
0
Eject button (^ EJECT)
This button is used to open the cassette holder.
0
EdIt-recording tape-speed selector
(EDITING SPEED)
This selector is used to select the recording speed when a
tape-to-tape recording is made.
0 Fast-forward/cue, rewtnd/revtew buttons
(^^CUE/REV ►►)
These buttons are used to advance or review the tape. During
playback these buttons are used to cue or review while listen­
ing to the contents at high speed. (Refer to page 20.)
0
Reverse-side playback button/IndIcator
(◄ PLAY)
This button is used to start the playback or recording (of deck
2 only) of side “B" of the cassette.
The indicator itluminates during playback or recording, and
flashes in the recording stand-by mode.
(The tape will move in the right-to-left direction.)
0
Stop button (■ STOP)
This button is used to stop the tape movement.
e Forward-side playback button/indicator
(► PLAY)
This button is used to start the playback or recording (of deck
2 only) of side “A” of the cassette.
The indicator illuminates during playback or recording, and
flashes In the recording stand-by mode. (The tape will move in
the left-to-right direction.)
<D Remote-control indicator
(REMOTE CONTROL)
This indicator Illuminates to indicate that this unit can now be
controlled by the remote-control transmitter.
0 Rewind auto edit button (REW AUTO EDiT)
This button is used to rewind the tape to the beginning and
start a tape-to-tape automatic recording.
0 Tape edit button/indicator (TAPE EDIT)
This button is used to start a tape-to-tape recording, simulta­
neously starting tape deck 1 (the playback deck) and tape
deck 2 (the recording deck). The indicator illuminates in this
mode,
<D Record-muting button (REC MUTE)
This button is used while recording a tape on deck 2 to insert
a silent interval on the tape. (Refer to page 33.)
0
Recording pause button/indicator
(REC PAUSE)
This button is used to activate the recording pause mode. The
indicator will illuminate when in this mode. (Refer to page 33.)
-12-