Panasonic SA-HD52 - Manual (Page 15)

fe;:':
Note:
tf a new broadcast station is preset into a channel, the broadcast station which was previously entered in that channel will be automatically erased.
Manual memory presetting
Stations can be freely preset to any desired channel.
A maximum of 24 broadcast stations can be memorized.
1
2
3
POWER
Switch ON the power **STANDBY Ò /ON”
switch.
INPUT SELECTOR T i m
Press the “TUNER" button. I— W1
BAND
Press the desired band selector (“FM”,
“LW" or “MW”).
MEMORY
B B . l U
im~j
Press the memory !
button momentarily.
(The memory indicator will illuminate.)-
Note:
If the memory button is pressed continuously, the auto­
matic memory presetting is activated. To stop the auto­
matic memory presetting, press the tuning button.
Then begin again from step 4.
s-s
Select the desired
“channel”
(Refer to "How to designate preset channels”, below.)
BB. /G„a
"channel"
fbOWNlitPI
Press the appropriate tuning button to tune
to the desired broadcast.
(Refer to "Frequency tuning” at the bottom of the previous
page.)
Repeat the above procedures to make
memory presettings; write the presettings
in the station log (page 18).
How to designate preset channels
*To designale channels 1-S: Press the appropriate (1-9) preset-
channel button.
•To designato channels 10*24:
(D Press the button for the left digit (1 or 2).
® Press the button for the right digit (0-9) within 2 seconds after
pres^ng the first button.
Example; To designate channel 12
Press the “1 "
iHJtton
and then ttte "2”
button.
Note:
If the interval between pressing the first button and pressing the
second button is more than about 2 seconds, the setting may not be
made correcfiy. If this happens, make the setting once again.
Wi
! -
Within 2 sec
/г
-15-