Panasonic SA-HD52 - Manual (Page 35)

m
Edit-Recording
1 2
“Edit-fecording" is recording from one tape to another.
4 3 5 6
1
2
3
Rewind auto
edit button
POWER
Switch ON the power “STANDBY 6/ON”
switch.
INPUT SELECTOR
Press the “TAPE“ button.
JRPE Ì
I EJECT I
Press the eject button on deck 2, and insert
the tape upon which the recording will be
made.
(The part of the cassette where the ^
tape is exposed should face down­
ward.)
I
Note;
The normal or chromium type of tape is recommended.
I EJECT I
Press the eject button on deck 1, and insert
the tape to be played back.
I REVERSE MODE |
Select the side(s) of the tape (one side only
or both sides) upon which the recording Is
to be made.
; Select this setting to record on one side only.
At this setting, the recording will stop at the erxl of
one side of the tape.
; Select this setting to record on both sides.
The recording will be made on side "B" after re­
cording on side “A”; the tape will stop at the end
of side “B".
(When the playback in the "B” side by deck 1 has
finished, tape movement in deck 1 will stop and
deck 2 will stop.
I EDITING SPEE d I
Select the speed at which the recording will
be made.
NORMAL; For operation at the normal tape speed.
HIGH; For operation at the high tape spe^.
7
1 TAPE EDIT I
Press the tape edit button.
The indicator will illuminate.
By pressing the tape edit button at this time, recording will
begin immediately at the present tape locations. (Playback
of deck f^ecording onto deck 2.)
Pressing the rewind auto edit button will cause both tapes
to rewind to their beginning, at which point recording will
start.
■ To stop edIt-recording
Press any of the stop button.
(Both of the tapes In the deck will st(^.)
Notes:
•Do not change the editing tape-speed setting while a recording is
being made. (To do so vt^ll cause a momentary sound distortion in
the recording.)
•The recording level as well as the equalizer effects and the Dolby
noise-reduction effects will be recorded on the tape in tape deck 2
exactly as they were originally recorded on the tape in the tape
deck 1.
•The monitor sound in Dolby recording can be played back
accurately if the Dolby noise reduction switch is set to "ON”.
•While an edIt-recording is in progress, you can enjoy some other
sources. Select the desired sound source by using the input
selectors, and start the performance.
Then again, when you want to listen to the tape on edit-recording,
press the 'TAPE” button of the input selectors of this unit.
•When performing the edit-recording, be sure to turn off the power
for the wdeo or TV product. (To do so will cause the distortion
sound may be recorded.)
-
36
-