Panasonic CT-36VG50 - Manual (Page 33)

Programming the Home Theater Remote
The remote control can be set to control other manufacturers components, by utilizing the MODE SELECTION
BUTTONS for CABLE, DSS, VCR, RCVR (a Receiver or Amplifier), CD, LD, and AUX (for Cassette Players, Second
VCR or a DVD.)
Code Known
Use the following procedure for setting up the
remote control using the numerical buttons
when the component's remote code is known.
m Determine the brand of the component.
f2l Identify the code(s) associated with the
brand from the infrared code index (see
following pages). Record all possible
codes.
~3l Confirm that the component is plugged
in and operating properly, then turn it
OFF.
[41 Press and hold thefSi button, then
the button so that both are
pressedat the same time for iileasil
I6jpiiic>hds. Then let go of the buttons.
m
Code From
Index Sheet
¿J Press the appropriate Mode button
for the component.
Enter the 3-digit code, by using the
Remote
Control Keypad “0"
through ”9” buttons.
Now the remote
entered code. ^
is set for the
m Press the button to test the remote. If
the correct code is setup for the
component (in step [E)i the component
will turn on. TNQ2AE012
Code Unknown
Use the following procedure for setting up the
remote control when the component's remote
access code is not known. This procedure
uses the "sequence method".
Confirm that the component is plugged
in and operating properly, then turn it
OFF.
Press and hold the button,
then the button so that both
are pressed at the same time for H
lilit^5"secdhcll. Then let go of the
buttons.
Press the appropriate Mode button
for the device.
H Press the button to step
over to the next code.
Press the button to test the
remote. If the correct code is
sent, the component will turn on.
@l Once the correct code is found,
press the button
to store the code.
Repeat from step [H] above until the
proper component code is found. It
may take several attempts before
the correct code Is found.
Note: Some brands have multiple codes.
Repeat the procedure using another
listed code until the component
responds correctly.
Note: If an incorrect code is entered, or
when the operation is not
completed within 30 seconds, the
settings will not change.
Infrared Remote Codes for Specific Components
Helpful Hint: Write down the code numbers for your components in the space provided below. This
will serve as a handy reference whenever you need to reprogram your remote control.
CABLE
Cable TV Converter Box
VCR
Video Cassette Recorder
CD
Compact Disc Player
!
□
DSS
Digital Satellite System
i
r
RCVR
Receiver or Amplifier
LD
Laser Oise Player j
□
Othnr Componsnt Other Component Other Component
□
□
I Other Component II Other Component I Other Component |
-
32
-