Panasonic PANAFLAT TX-D5L31F - Manual (Page 2)

IMPORTANT NOTICE CONCERNING POWER CORD SELECTION
The power cord for this unit has been packed separately and has been selected according to the country of
destination and must be used to prevent electric shock. Use the following guidelines if it is necessary to replace
the original cord set.
The female receptacle of the cord set must meet CEE-22 requirements and will look like Figure 1:
For the United States and Canada:
In the United States and Canada the male plug is a NEMA 5-15 style (Figure 2) and is UL listed and CSA
labelled. For units which are mounted on a desk or table, type SVT or SJT cord sets may be used. For units
which sit on the floor, only SJT type cord sets may be used. The cord set must be selected according to the
current rating for your unit. Please consult Table A for the selection criteria for power cords used in the United
States and Canada.
For European Countries:
In Europe you must use a cord set which is appropriate for the receptacles in your country. The cord set
Is HAR-CertIfled, and the mark 4 HAR^ will appear on the outer sheath, or on the Insulation of one of the
Inner conductors.
If you have any questions concerning the proper power cord to use, please consult with the dealer where you
purchased your unit.
Table A
Cord Type Size of Conductors In Cord Maximum Current Rating of Unit
SJT 18AWG lOAmps
16AWG 12Amps
14AWG 12Amps
SVT 18AWG 10 Amps
17AWG 12 Amps
Figure 1 Figure 2
Federal Communications Commission Requirements
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio / TV technician for help.
FCC Warning:
To assure continued FCC compliance, the user must use the provided grounded power supply
cord and shielded interface cable with bonded ferrite cores. Also, any unauthorized changes or
modifications to this monitor would void the useris authority to operate this device.
- 1 -