Panasonic PANAFLAT TX-D5L31F - Manual (Page 5)

I Precautions |
1) Installation
• Install the monitor in a well ventilated place. Avoid exposing to direct sunlight, a
heater, or any other heat source. Heat will adversely affect the cabinets and the
parts inside.
• Position the display unit so that the holes in the cabinet will not be blocked during use.
• Keep the display unit away from the kitchen, bathroom, washing machine, or other
sources of exposed to water, steam or moisture.
• In order to use the display unit safely, use only the supplied AC line cord. The AC line
cord must be used with a properly grounded and polarized power supply socket. The
AC line cord supplied is for the USA (UL) and Canada (CSA) with the display unit.
For use in other countries, make sure the AC line cord meets the safety standards of
the country.
• Place the AC line cord where it will not be subject to stress.
• Use only Panasonic provided accessories or the exact equivalent.
2) Usage
• Pulling on the AC line cord or VGA Signal Cable can damage the display unit
(monitor) and can cause the unit to fall and possibly cause personal Injury.
• Receiving trouble.
If there is a television set or other display unit nearby, keep your display unit as far
away from it as possible. Mutual interference can cause image distortion or noise.
• Long exposure to rubber or vinyl products can stains the cabinet.
• Keep the monitor from physical shock when moving. Be careful of the Active Matrix-
Liquid Crystal Display (AM-LCD).
• Do not place anything on the monitor.
• Also take good care of the power cable.
Do not place any objects on the power cable. Do not attempt to extend, shorten on tie
it into a knot.
3) Product Care
• Prior to cleaning your display unit, disconnect the VGA Signal Cable from the display
unit.
• Use a clean, soft, dry cloth to clean the outside of the monitor or the AM-LCD surface.
If the monitor or AM-LCD surface is very dirty, wet a clean, soft cloth with neutral
detergent (such as dishwashing detergent) and water, squeeze it tight until almost dry,
wipe the monitor or AM-LCD surface with it, and finish by wiping with a clean dry cloth.
Do not use any solvents.
• Do not rub or strike the AM-LCD with anything hard or harsh as this may scratch, mar
or damage the AM-LCD permanently.
• Do not use a chemical duster or polish-cleaner because it can adversely affect the unit
and peal the paint coat.
- 4 -