Additional safety rules, Important notice – Panasonic EY6930 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
22)
Use of an attachment not recom
mended may result in a risk of fire,
electric shock, or injury to persons.
23) Do not short the battery pack. A bat
tery short can cause a large current
flow, over heating and burns.
24) NOTE: If the supply cord of this appli
ance is damaged, it must only be
replaced by a repair shop appointed
by the manufacturer, because special
purpose tools are required.
25) TO REDUCE THE RISK OF ELEC
TRIC SHOCK, THIS APPLIANCE HAS
A POLARIZED PLUG (ONE BLADE IS
WIDER THAN THE OTHER).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
7) When storing or carrying the tool, set
the reversing lever to the center
(switch lock) position.
8) Do not strain the tool by holding the
. speed control trigger halfway (speed
control mode) so that the motor stops.
9)
Do not operate the speed selector
switch (LOW-HIGH) while pulling on
the speed control trigger. This can
cause the
rechargeable battery
to
wear quickly or damage the internal
mechanism of the motor.
Changes or modifications not
expressly approved by
MATSUSHITA ELECTRIC WORKS,
LTD. could void the user’s authority
to operate the equipment.
ADDITIONAL
SAFETY RULES
1) Be aware that this tool is always in
an operating condition, since it does
not have to be plugged into an elec
trical outlet.
2)
When drilling or driving into walls,
floors, etc., “live" electrical wires may
be encountered. DO NOT TOUCH
THE
CHUCK
OR
ANY
FRONT
METAL PARTS OF THE TOOL! Hold
the tool only by the plastic handle to
prevent electric shock in case you
drill or drive into a “live” wire.
3) If the bit becomes jammed, immedi
ately turn the main switch off to pre
vent an overload which can damage
the
battery
pack
or
motor.
Use
reverse motion to loosen jammed bits.
4)
Do not operate the reversing lever
when the main switch is on. The bat
tery will discharge rapidly and dam
age to the unit may occur.
5)
During charging, the charger may
become slightly warm. This is nor
mal. Do not charge the battery for a
long period.
6) Use only a dry, soft cloth for wiping
the unit. Do not use a damp cloth,
thinner, benzine, or other volatile sol
vents for cleaning.
IMPORTANT NOTICE
PLEASE READ THIS ENTIRE
NOTICE BEFORE OPERATING .
. YOUR NEW PANASONIC
CORDLESS POWER TOOU
PANASONIC’S CHARGING
SYSTEM UTILIZES A QUALITY HIGH
TEMPERATURE NICKEL CADMIUM
BATTERY PACK IN CONJUNCTION,
WITH OUR SELF-DIAGNOSTIC
UNIVERSAL INVERTER CHARGER; ^
'THIS HIGH TEMPERATURE NICKEC
CADMIUM BATTERY PACK ; v:/''
REQUIRES A "BREAK-IN PERIOD"..
TO REACH
MAXIMUM OPERAVNG
CAPACITY. THE
^ ■
“BREAK-IN PERIOD” IS
ACCOMPUSHED DURING NORMAL
USAGE DURING THE FIRST 6-8
CHARGE AND DISCHARGE
CYCLES OF THE BATTERY PACK.;;^
AFTER THE "BREAK-IN PERIOD" IS
COMPLETED, THE BATTERY PACK
WILL MAINTAIN
MAXIMUM
ù
: ;
OPERATING CAPACITY
THROUGHOUT THE NORMAL UFE‘ '
, Of THE BATTERY PACK. . ,
_
4
_