Panasonic EY6930 - Manual (Page 6)

PARTIDENTIRCAT10N
(S)
Keyless drill chuck
Note; When attaching or removing a
bit, be sure to set the reversing
lever
to its center position
(switch lock).
This tool is equipped with a keyless
drill chuck.
1. Attachment
Insert the bit and turn the k>ck col­
lar clockwise ( looking from the
front) to tighten firmly.
Slide the Lock collar to LOCK side.
Lock collar
2. Removal
Slide the Lock collar to FREE side.
Turn the lock collar counterclock­
wise (looking from the front), then
remove the Ut. , ,
Lock collar
®FREE
Note: If the bit cannot be removed by
hand, insert the lock release
rod or a similar tool into the
hole located on the chuck to
release the lock, and then turn
the lock collar counterclock­
wise (viewed from the front).
Chuck
(To prevent accidental operation,
remove the battery pack before trying
to remove the bit.)
Note; If excessive play occurs in the
chuck, (D secure the drill in place
and tighten the chuck by turning
clockwise, d) open the chuck
daws by unscrewing the lock col­
lar and (d tighten the screw (left-
handed screw) with a screwdriver
by turning it counterclockwise
(viewed horn the front).
®
®i
Clutch Handle
(Clutch Torque Setting)
Adjust the torque to one of the 5 pos­
sible settings to the job.
CAUTION: Test the setting before
actual operation.
Set the scale at this line
Reference for Adjusting Torque
Seal« Torque Use
1
Approx. 1.0 Nm
(10 kof-cm or 8.7 in-l».)
R k driving
terminal screws
2
Approx. 1.5 Nm
(15 kgl-cm or 13.0 irt-IbB.)
For driving
machine screws
3
Approx, 2,6 Nm
(25 kgf-cm OT21.7 In-lbs.)
For driving Mrews
irttosoflfflUwlBls
4
Approx. 3.4 Nm
(35 kgf-cm or 30.4 in-lbs.) For driving
5
Approx. 4.4 Nm
(45 kgf-cm or 38.0 tn-lbs.)
hardwood
qa
19.6 Nm 200kgf-cm,
173.4 in-Kw. (Low speed) Forpoweiftjl
driving mddriHng
r
Percussion
For drWng to mor­
tar, brick etc.
-
6
-