Panasonic EY6930 - Manual (Page 7)

Bit-locking function
1. With the trlg^r switch not engag^
and a screwdriver bit locked in
piace, and the tool can be used as
a manual screwdriver (up to
22.5Nm, 230kg-cm, 199in-lbs.).
There will be a little play in the
chuck, but this is not a malfunction.
©
2. This feature is handy for tightening
screws that require more torque
than the maximum torque of the
driver (position csi on the dutch),
for confirming the tightness of a
screw or to loosen an extremely
tight screw.
Reversing lever
(Forward (0).Switch lock,Revofse O))
CAUTION: Release the trigger
switch to OFF and wait
until the bit has come to
a complete stop before
operating this lever.
1. For reverse rotation, set the lever
to reverse. Check the direction of
rotation before use.
2. After use, set the lever at the cen­
ter (switch lock) position.
Variable apeed control trigger
1. The speed increases with the
amount of depression of the trig­
ger. When beginning work, de­
press the trigger slightly to start
the motion slowly.
2. A feedback electronic controller is
used to give a strong torque even
In low spi^.
3. The brake operates when the trig­
ger is released and the motor
stops immediately.
Note: When the brake operates, a
braking sound may be heard.
This is normal.
© Speed selector switch
Choose a low or high speed to suit
the use.
The more the speed control trigger is
, pulled, the higher the speed.
CAUTION: Check the sp^ selection
before operatirtg this tool.
© Battery pack (EY9136/EY9230)
1. Press the battery pack release
buttons ® on both sides and pull
the pack away from the toot.
2. Charge the battery pack using the
battery charger.
3. After the charging has been com­
pleted, remove the battery pack
from the charger and connect it to
the tool. Disconnect the charger
from the A.C. outlet when not in
use.
CAUTION: When operating with a Ni-MH
battery pack (EY9230) make
sure
the place is well-
ventilated.
Battery Pack Life
The rechargeable batteries have a limited
life.
If the operation time becomes
extremely short after recharging, replace
the battery pack with a new one.
ATTENTION (EY9136 ONLY):
The nickel cadmium battery you have
purchased is recyclable. At the end of Ifs
useful life, under various state and local
laws, it is illeg^ to dispose of this battery
into your municipal waste stream. Please
call 1-800-8-BATTERY for information on
how to recycle this battery.
© Battery pack release button
-
7
-