Connecting an amplifier with a built-in decoder – Panasonic DVD-RV40 EN User Manual

Page 35

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

D

Connecting an amplifier with a built-in decoder

You can enjoy the multi-channel surround sound found on DVD recorded with Dolby Digital, DTS Digital Surround or MPEG by connecting an

amplifier with a built-in decoder or a separate decoder-amplifier combination.

' l \ '

°dò^

0 CZnDCTD

@@@

OPTICAL COAXIAL

0

‘""Lj.;, ;,i.— ------------------

Note when connecting the optical digital audio cable

Align the plug with
the terminal

Dust protection

cap

• Remove the dust protection cap from the optical digital audio

output terminal and connect the cable firmly so that the
configurations of both the cable and the terminal match.

• Keep the dust protection cap and reattach when not using the

terminal.

Optical digital audio cable

• Do not bend the optical digital audio cable when connecting it.

Coaxial audio cable

DVD-RV40

Amplifier with a built-in decoder

• Read the instructions for the amplifier and speakers for

connection details.

Speakers

(You can connect from 3 to 5 speakers including the front two.)

• Front speakers (L/R)
•Center speaker

• Surround speakers (L/R)
• Subwoofer

When you have finished connection
Make changes to “7 Digital Audio Output” to suit your decoder (■► page 37).

Decoder

Item

Dolby Digital decoder

DTS Digital Surround

decoder

Dolby Digital/

DTS Digital Surround

decoder

Dolby Digital/

DTS Digital Surround/
MPEG audio decoder

PCM Down Conversion

Yes^

Yes^

Yes^

Yes^

Dolby Digital

Bitstream

PCM

Bitstream

Bitstream

DTS Digital Surround

Off

Bitstream

Bitstream

Bitstream

MPEG

PCM

PCM

PCM

Bitstream

^If this is set to “No”, no audio will be output when DVDs recorded in 96 kHz linear PCM are played. (Audio will be output as it is if the DVD does

not have copyright protection recorded on it.)

•These changes to digital audio output must be made, otherwise bitstream signals the decoder cannot handle will be output. If

these signals are output, “noise” will be output which can cause harm to your ears and speakers.

•You cannot use DTS Digital Surround decoders not suited to DVD.
•Additional equipment and cables are not supplied.

VQT8633

Advertising
This manual is related to the following products: