Panasonic TC 42P1F - Manual (Page 27)

Signal Menu
1 Push the “Menu” Button.
MENU 1,2
3
2.Select the “Signal” Menu by pushing the
Position Up “A”or Down “T” Button and
Access the “Signal” Menu by pushing the
“STR” Button.
3.Select the required mode by pushing the
Position Up “A" or Down buttons, and
set the appropriate function by the Position r
Left or Right buttons. ^
Note:
(1) The “Signal” screen changes depending on the input signal mode (AV(S-Video), Component, RGB or PC).
During “AV{S-Video)" input
signal mode
During “AV(S-Video)” input signal mode
Select the mode Sj
Select the function
I
4
I
I ►
1
Signal
[S
cm O CB~ Change
Colour system
Scan mode
Field
Mode Function
Colour system Set the colour system to match the input signal. If set to “Auto”, the colour system is
determined automatically.
Note:
(1 )The display colour for the input signal mode (“AV”) changes
according to the colour system
—> Auto <—> NTSC <r
^SECAM^PAL^
setting.
Auto - Green NTSC - Magenta
PAL - Yellow SECAM - Cyan
(2) PAL-60 signal is displayed only
“Auto” mode.
Scan mode __ >Pjeid<__ watching a normal image, select the “Field”.
j-^ I recording mode used for a device such as a digital video camera is
>Framed “Frame”, select the “Frame” to obtain a higher-quality playback image.
During “Component” input signal mode
Select 3] CB
Signal
C3Q
O Œ-Change
Colour mntrix
Mode Function
Colour matrix If the output signals from the source connected to the COMPONENT/RGB input terminals are
in 525p (480p) format, the colours in the images from this source will be set to their natural
colours.
27