Panasonic EY6406 - Manual (Page 3)

13) Do not force tool. Use the correct
tool for your application.
The correct tool will do the job better
and safer at the rate for which it is
designed.
14) Do not use tool if switch does not
turn it on or off.
A toot that cannot be controlled with
the switch is dangerous and must be
repaired.
15) Disconnect battery pack from tool
or place the switch in the locked or
off position before making any
adjustments, changing acces­
sories, or storing the tool.
Such preventive safety measures
reduce the risk of starting the tool acci­
dentally.
16) Store idle tools out of reach of
children and other untrained per­
sons.
Tools are dangerous in the hands of
untrained users.
17) When battery pack is not in use,
keep it away from other metal
objects like: paper clips, coins,
keys, nails, screws, or other small
metal objects that can make a con­
nection from one terminal to
another.
Shorting the battery terminals togeth­
er may cause sparks, bums or a fire.
18) Maintain tools with care. Keep cut­
ting tools sharp and clean.
Properly maintained tools with sharp
cutting edge are less likely to bind
and are easier to control.
19) Check for misalignment or binding
of moving parts, breakage of parts,
and any other condition that may
affect the tool’s operations. If dam­
aged, have the tool serviced before
using.
Many accidents are caused by poorly
maintained tools.
20) Use only accessories that are rec­
ommended by the manufacturer
for your model.
Accessories that may be suitable for
one tool may create a risk of injury
when used on another tool.
Service
21) Tool service must be performed
only by qualified repair personnel.
Service or maintenance performed by
unqualified personnel may result in a
risk of injury.
22) When servicing a tool, use only
identical replacement parts. Follow
instructions in the Maintenance
section of this manual.
Use of unauthorized parts or failure to
follow Maintenance Instructions may
create a risk of shock or injury.
SPECIFIC SAFE­
TY RULES
1) Hold tool by insulated gripping
surfaces when performing an
operation where the cutting tool
may contact hidden wiring.
Contact with a “live” wire will also
make exposed metal parts of the tool
“live” and shock the operator
Symbol meaning
V Volts
—
Direct Current
no load speed
„irnin
revolution or
reciprocation per minutes
Rotation only
-
3
-