Save these in­ structions, For battery charg­ er & bahery pack, Caution – Panasonic EY6406 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

FOR BATTERY CHARG­
ER & BAHERY PACK

> SAVE THESE IN­

STRUCTIONS ™.

manual contains important safety and
operating

instructions for battery

charger EY0230.

2) Before using battery charger, read all

instmctions and cautionary markings
on (1) battery charger. (2) battery
pack.

3)

CAUTION

-To reduce the risk

of injury, charge only Battery Pack
shown below.

EY9001, EY9080, EY9065. EY9006,
EY9086, EY9101, EY9180, EY9182,
EY9106, EY9107, EY9136, EY9230,
EY9200, EY9108

Other types of batteries may burst

causing personal injury and damage.

4) Do not expose charger to rain or

snow.

5) To reduce risk of damaging the elec­

tric plug and cord, pull by ^ug rather
than cord when disconnecting charg­

er.

6) Make sure cord is located so that it

will not be stepped on, tripped over,
or otherwise subjected to damage or
stress.

7) An extension cord should not be

used unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric

shock. If extension cord must be

used, make sure:

a. that pins on plug of extension cord

are the same number, size and
shape as those of plug on charger.

b. that extension cord is properly

wired and in good electrical condi­
tion.

c. that wire size is large enough for

ampere rating of charger as speci­
fied below.

- 4

RECOMMENDED MINIMUM AWG SIZE OF

EXTENSION CORDS FOR

BATTERY CHARGERS

AC Input Rating. Amperes

AWG Size of Cord

Equal to or But less

greater than than

Length of Cord, Feet

25 50 too 150

0 2

18 18 18 16

8) Do not operate charger with dam­

aged cord or plug—replace them
immediately.

9) Do not operate charger if it has

received

a

sharp

blow,

been

dropped, or otherwise damaged in
any way; take it to a qualified service­
man.

10) Do not disassemble charger; take it

to a qualified serviceman when ser­
vice or repair is required. Incorrect

reassembly may result in a risk of

electric shock or fire.

11) To reduce the risk of electric shock,

unplug charger from outlet before
attempting

any

maintenance

or

cleaning.

12) The charger and battery pack are

specifically designed to work togeth­
er. Do not attempt to charge any
other cordless tool or battery pack
with this charger.

13) Do not attempt to charge №e battery

pack with any other charger.

14) Do not attempt to disassemble the

battery pack housing.

15) Do not store the tool and battery

pack in locations where the tempera­
ture may reach or exceed 122°F
(SOX) (such a metal tool shed, or a

car in the summer), which can lead to

deterioration of the storage battery.

16) Do not charge battery pack when the

temperature is BELOW 32°F (0“C) or
ABOVE 104°F (40°C). This is very
important.

17) Do not incinerate the battery pack. It

can explode in a fire.

Advertising
This manual is related to the following products: