Panasonic EY6406 - Manual (Page 8)

Clutch Torque Setting
Adjust the torque to one of the 18 possi­
ble settings or “ g" position to the job.
CAUTION: Test the setting before actual
operation.
Set the scale at this line
Note: When the brake operates, a braking
sound may be heard. This sound
indcates engagement of the bit lock.
CAUTION: To eliminate excessive tem­
perature increase of the tooi
surface, do not operate the
tool continuously using two or
more battery packs.
Tool needs cool off time before
switching to another pack.
* Do not close up vent holes on
body sides of the body during
operation.
Otherwise, the machine func­
tion is adverseiy affected to
cause a failure.
• Do not strain the tool (motor).
This may cause damage to
the unit.
* Use the machine in such a
way as to prevent the air from
the body vent holes from
blowing directly onto your
skin. Otherwise, you may get
burnt.
• When operating with a Ni-MH
battery pack, make sure the
place is weii-ventiiated.
For Appropriate use of Battery pack
Ni-MH Battery pack
(EY9108/EY9200/EY9230)
• Charge the Ni-MH battery fuliy before
storage in order to ensure a ionger ser­
vice life.
• The ambient temperature range is
between O^C and 40“C.
if the battery pack is used when the
battery temperature is beiow 0“C. the
tooi may fail to function properly. In
that, charge the battery until charg­
ing is completed for appropriate
functioning of the battery.
Ni-Cd Battery pack
(EY9106/EY9136)
* Nickel cadmium battery pack rec^ires
a "BREAK-IN PERIOD’ to reach maxi­
mum operating capacity. The
•BREAK-IN PERIOD is accomplished
during normal usage during the first 6-
8 charge and (fist^iarge cycles of the
battery pack.
After the ‘BREAK-IN PERIOD is com-
pieted, the battery pack will maintain
maximum operating capacity through­
out the normal life of the battery pack.
Battery Pack Life
The rechargeable batteries have a
limited life. If the operation time
becomes
extremely short after
recharging, replace the battery pack
with a new one.
Charging
Note: When you charge the battery
pack for the first time, or after
prolonged storage, charge it for
about 24 hours to bring the bat­
teries up to full capacity.
EY0230
1. Plug the charger into the AC outlet.
Note: * Sparks may be produced when
the plug is inserted Into the AC
power supply, but this is not a
problem in terms of safety.
2. Insert the battery pack firmly into
the charger.
3. During charging, the charging lamp
will be lit.
When charging is completed, an
internal electronic switch will auto­
matically be triggered to prevent
overcharging.
-
8
-