Panasonic WV-CU20 - Manual (Page 109)

® VCR CONTROL PANEL
Opens the VCR control panel on the bottom center oi
the window.
(D VCR/CAMERA SELECT
Alters the FS616's output between the VCR playback
and live camera image,
® MULTISCREEN SELECT
Clicking this button repeatedly will switch the screen
segments as follows:
4 - > 7 - ^ 9 - > l 0 ^ l 3 - > l 6 - > 4 screen segments
® SEQUENCE
The sequential images preset to the WJ-FS616 are dis­
played.
® PRESET SELECT (Bottom window panel)
To move the combination camera (option) connected to
the WJ-FS616 to any of 64 preset positions. Select a
preset position number, and then click the [SET] button
to move the camera to the position.
® ALARM ALL RESET
To reset all alarms activated in the Video Multiplexer,
and return it to normal condition.
® PAN7T1LT
Click on any of the pan/tilt buttons: Up, Down, Right or
Left to move the pan/tilt head of the Combination cam­
era to the desired direction. Click the button repeatedly
as necessary not holding down it.
© ZOOM
Click the button to ^oom in or out. Instead holding
down the button, click on it repeatedly as necessary.
TELE: Zooms in the image,
WIDE: Zooms out the image.
© FOCUS
Click NEAR or FAR to adjust the focus of the image
manually. Instead holding down the button, click on it
repeatedly as necessary,
NEAR: Manual focusing
FAR: Manual focusing
AUTO: The built-in focus mechanism performs in the
Combination camera,
© IRIS
The connected combination camera (option) can be
controlled to close or open the iris by clicking the
[CLOSE] or [OPEN] button under IRIS,
Clicking the [OPEN] or [CLOSE] button will open or
close the camera iris for a specified time, after which
the operation is released automatically.
Clicking the [RESET] button on the screen will reset
the iris of the displayed camera to the factory default
setting. Iris control cannot be retained by keeping the
[OPEN] or [CLOSE] button depressed. You need to
click the [OPEN] or [CLOSE] button again.
© AUTO PAN
The auto pan status of the connected combination
' camera (option) can be changed by clicking the [ON]
or [OFF] button under AUTOPAN.
Note: Note: When LOCAL is selected in the camera
setup menu, auto pan is released automatically
within 1 minute. When REMOTE is selected, auto
pan will not be released automatically.
® Status Window
Displays information when an alarm is activated on the
WJ-FS616.
© Image Display
Displays the image output supplied from the MULTI­
SCREEN OUT connector on the video multiplexer to the
WJ-NT204.
109