Panasonic AG-520D PROLINE - Manual (Page 5)

Unhook the antenna from your
previous TV or VCR and
connect it to the back of the
Combination VCR as shown in
the diagram.
If your antenna system has
separate UHF and VHF lead-
ins, you need a UHFA/HF
Band Mixer (not supplied).
WARNING:
When using “Nut type" RF coaxial
cables, tighten with fingers only.
Overtightening may damage
terminals.
from
Antenna 300-75 ohm
Transformer
(not supplied)
(Flat)Twin Lead
300 Ohm Cable
DSS/Cable box Connections
■ Without a Cable Box
You can;
• record or view unscrambled channels.
You cannot:
• record or view scrambled channels.
• view a channel other than the one
selected for any type of recording.
Combination VCR
■ With a Cable Box
You can;
• record or view any channel including scrambled channels.
NOTE: Channel selection must be made at the cable box.
You cannot;
• view a channel other than the one selected for any
type of recording.
• do a Timer recording of a channel unless you select it
at the cable box.
Note to CABLE System Installer
This reminder is provided to call the CABLE (Cable TV) System
Installers attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding system
of the building, as close to the point of cable entry as practical.
Combination VCR
■ With a DSS Receiver
You can;
• record or view any channel including scrambled
channels.
NOTE: Channel selection must be made at the DSS Receiver.
You cannot;
• view a channel other than the one selected for any
type of recording.
• do a Timer recording of a channel unless you select it
at the DSS box.
NOTE: The DSS receiver must be turned off to view programs from
a cable box or antenna. See the DSS manual for details.
• DSS® is registered trademark of DIRECTV, INC., a unit of GM
Hughes Electronics.
Combination VCR
DSS Receiver