Panasonic CQ-DF783U - Manual (Page 44)

Installation Guide
Ж WARNING
This installation information is de­
signed for experienced installers and is
not intended for non-technical individu­
als. It does not contain warnings or cau­
tions of potential dangers Involved in
attempting to install this product.
Any attempt to install this product in a
motor car by anyone other than quali­
fied installer could cause damage to the
electrical system and could result in se­
rious personal injury or death.
□ Installation Hardware
No. Item Diagram Q’ty
0 Mounting collar 1
CD Hex. nut (5 mm<^) 1
Rear support strap 1
0 Tapping screw
(5 mm0x16 mm)
1
Mounting bolt (5 mm0) 1
(D Power connector 1
© Removable face plate
case
1
(D Trim plate 1
CD Lock cancel plate 2
□ Overview
This product should be installed by a professional.
However, if you plan to install this product yourself,
your first step is to decide where to install it. The in­
structions in these pages will guide you through the
remaining steps:
(Please refer to the “WARNING” statement
above.)
• Identify and label the car wires.
• Connect the car wires to the wires of the power
connector.
• Install the unit in the dashboard.
• Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Caution:
• This unit operates with a 12 V DC negative
ground auto battery system only. Do not at­
tempt to use it in any other system. Doing so
could cause serious damage.
Before you begin instailation, look for the items
which are packed with your unit.
• Warranty Card... Fill this out promptly.
• Panasonic Servicenter List for Service Directory
...Keep for future reference in case the product
needs servicing.
• Installation Hardware... Needed for in-dash in­
stallation.
□ Required Tools
You'll need a screwdriver, a 1.5 V AA battery, and
the following:
12 V DC Electrical Side-cut
Test bulb tape pliers
□ Dashboard Specifications
Thickness Min. Уш" (4.75 mm)
Мах.Узг" (5.56 mm)
w
] 2Узг" (53 mm)
7Узг" (182 mm)
44
CQ-DF783/DFX403U