Before requesting service, Vtr wii! not operate correctly, Other functions before requesting service – Panasonic NVSD200BA User Manual
Page 17: Playback will not operate correctly, Recording wifi not operate correctly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before Requesting Service
Other Functions
Before Requesting Service
Before requesting service, check the following points once again.
VTR wii! not operate correctly
SYMPTOM
CAUSE
REMEDY
CHECKED
VTR display is not
illuminated.
Mains lead is not connected.
Reconnect mains lead to VTR.
VTR display is
illuminated but VTR
will not operate.
VTR is in timer mode.
Press TIMER REC to operate VTR manually.
Safety devices are operating.
Disconnect mains lead and wait for 1 minute.
Reconnect mains supply and check functions.
Condensation may have
formed.
Do not operate VTR for 1 hour.
Playback will not Operate correctly
SYMPTOM
CAUSE
REMEDY
CHECKED
Picture noisy or not
in colour.
Horizontal bars or
lines run down the
screen.
Tracking is not correct.
Adjust the tracking. See page 9.
TV set is not tuned to VTR.
Operate test switch on VTR and check TV tuning.
See page 4.
Video heads are clogged or
worn.
Consult your dealer for further advice.
Recording wifi not operate correctly
SYMPTOM
CAUSE
REMEDY
CHECKED
indication
flashes whenever
recording is
attempted.
Erasure prevention tab on
cassette is broken off.
Use tape with intact erasure prevention tab, or cover
tab hole with adhesive tape, if original recording is no
longer required.
Picture Is recorded
with noise or blank
screen.
Aerial or aerial lead is
defective.
Check aerial connection to VTR. See page 3.
Check your normal TV picture. If there is no picture,
check your aerial.
VTR is not correctly tuned.
Re-tune VTR. See page 6.
Timer recording
cannot be
performed.
Clock or calendar is
incorrectly set.
Check clock and calendar. Set to present time.
{Note this is a 24 hour clock.) See page 5.
Recording start or end time
settings are incorrect.
Set recording start and end time correctly.
VTR is not set for timer
recording.
Press TIMER REC after programming for timer
recording.
AV external
recordings cannot be
made.
AV is not selected.
Select AV by pressing v /N.
External AV connections are
incorrect.
Check that connections for external video and audio
source are correct. See page 13.
17