Panasonic SC-CH75 - Manual (Page 15)

Program play
by remote control only
This function allows you to program up to 24 tracks.
This example shows how to program track 8 from disc 2 and track 3
from disc 5.
1
2
Press B/CD.
PROGRAM
Press PROGRAM.
“PROGRAM" will light.
4JJJ JJJJ
JJJJ
DISC
Press DISC.
JJ4J
jjJj
JJJJ » «
JJJJ <AlJr n
O
(within 10 seconds or so)
Press Disc 1-5, whichever
disc you want.
JJJJ
o
0 Press or, ^ to select
the desired track number.
CD WC> C(K2
o o
PRotRAM^ ® (within 10 seconds or so)
Press PROGRAM.
Programmed track ilumber
Programmed order
JJJJ / / O
™ ^ G ■■ -
Repeat steps 3 through 5 untii
you have programmed aii the
tracks you want.
Press ►.
Play will start in the programmed se­
quence.
When all the programmed tracks have
been played, the changer will stop auto­
matically.
"P" of the program play mode will appear
on the display.
To cancel program play;
press ■. (Press ■ twice during program play).
To check programmed tracks:
Press or when “P" appears on the display.
Track number and the programmed order will appear on the display.
To add a programmed track:
Repeat steps 3 through 5 when “P” appears on the display.
To cfear a programmed track one by one:
Press CANCEL when “P" appears on the display.
Each time you press the button, the last programmed track will be
cancelled.
When “CD FULL” appears;
The number of programmed tracks is limited to 24. No further tracks
can be programmed.
For your reference
The program will remain stored in memory for approximately two
weeks even after the unit is switched off.
lyiwa
If you enter non-existing disc(s) or track(s), the corresponding indica­
tor illuminates and the entry is included in the count. In the play
mode, the changer will cancel the non-existing entry.
15