Rack mount adaptor (option), Installation of the ag-m730-e, Remove the 4 screws – Panasonic AG7150 User Manual
Page 45: Use the 4 screws supplied, Mounting on the lec standard rack, Remove the 4 rubber legs, Mount the unit on the rack, Installation of slide rails
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Rack Mount Adaptor (Option)
The Rack Mount Adaptor AG-M730-E is used to mount the unit on the I EC standard rack.
Installation of the AG-M730-E
1. Remove the 4 screws
from the side cabinet of the unit.
2. Use the 4 screws supplied
with the AG-M730-E to install it to the unit.
notch down
Mounting on the lEC standard rack
1. Remove the 4 rubber legs
from the bottom of the unit.
lEC standard rack
2. Mount the unit on the rack.
Be sure to install a ventilation fan (air volume of about 3.3 m
2/sec.) on the top of the rack.
Installation of slide rails
Use a complete slide rail and bracket unit for 18" length (part
No. CC3004-99-0017) or 24" length (part No. CC3004-99-0018)
of Chassis Track. (The complete slide rail and bracket unit is
not available from Panasonic.)
When using the slide rail, remove the setscrews. The setscrews
can be removed by pulling in the direction of the arrow. Keep
the removed setscrews, washers and spacers in a proper
place.
Setscrew y
Washer
For the details, contact your authorized service personnel.
A
L Spacer
a.
O
45