Setting the date and time, I owl b/ i owl – Panasonic EW3122 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE STARTING MEASUREMENTS
Setting the date and time
* Please be sure to set the date and time before taking the first measurement after
purchasing the blood pressure monitor or after changing the batteries.
• If measurements are taken without setting the date and time, the date and time
will not be stored.
Please read the "Caution when using only the AC adapter" on p. 10.
With the power switched off,
hold
the Set
button "1" below the display
pressed for
at least 3 seconds.
The month value will blink.
la
r'(/
I owl
B/ I owl
8/
3
ttOOl
8/
3 I5W
I
8/
3 t^:30]
1
If the time is already set, and the button is
pressed for a short time, the alarm setting
display will be shown.
2
3
4
5
6
Set the month.
Press
the Change button ”2"
repeatedly to set
the correct month.
Set the day.
0 Press
the Set button "1".
The day value will blink.
® Press
the Change button "2"
repeatedly to set the
correct day.
Set the hour.
0 Press
the Set button "1
". The hour value will blink.
® Press
the Change button "2"
to set the correct
hour.
Set the minute.
0 Press
the Set button "1
". The minute value will
blink.
® Press
the Change button "2"
repeatedly to set the
correct minute.
Press
the Set button "1"
at the exact time the
minute changes
to finalize
the date/time
setting.
7
Press
the On/Off Start button
to switch
off
the power.
When the date or time are blinking, the clock is stopped.
During leap years, 3/1 will be displayed on February 29. For this reason, reset the date
to 2/29.
POSITIONING THE PRESSURE CUFF
1
<When wrapping around left arm>
Position the tube outlet
so that It is on the palm
side of the arm in line
with the little finger of
the hand.
Tape fastener
Open the cover and
remove the
pressure cuff
from the
main body. (See p. 8.)
Insert
the plug into the
socket.
• Insert the pressure cuff plug
all the way in.
2 Wrap
around upper arm.
• Wrap around bare arm.
The blood pressure monitor can
be used by wrapping the cuff on
either upper arm. However,
since it has been said that the
difference in blood pressure
between the left and right arms
may be around lOmmHg, be
sure to always use the same
arm tor measurements.
Fasten
so that there is no
gap between the cuff and the
arm, but be careful that the cuff
is not too tight.
• Be careful not to catch your
clothes when wrapping the
cuff. (Doing so may lead to
lower accuracy.)
• Press the tape fastener
down well.
11
12