Panasonic KX-P3626 - Manual (Page 31)

Initial
®gíц^WlsSs
Menu Item ^ Setting Description
INTERFACE
[The setting is
effective only
when the
optional
KX-PS14,
RS-232C
serial interface
board is
installed.]
INTERFACE PARALLEL*
SERIAL
Selects parallel interface or
serial interface.
DATA LENGTH 8 BITS*
7 BITS Selects data length 8 bits or 7
bits.
BAUD RATE +1 150 BPS 2400 BPS
300 BPS 4800 BPS
600 BPS 9600 BPS*
1200 BPS
Selects the desired baud rate.
PARITY *1 NONE* ODD
IGNORE EVEN
Selects the desired parity.
PROTOCOL *1 DTR*
XON/OFF
Selects the desired protocol
DTR or XON/OFF.
SDT *1 RBC 128*
RBC 512 Selects the remaining buffer
capacity (R.B.C.) 128 byte or
512 byte to suspend data
transfer (S.D.T.) (X/OFF).
RDT+1 SDT+128*
SDT+256 Selects the remaining buffer
capacity (R.B.C.) 128 byte or
256 byte to resume data
transfer (R.D.T.) (X/ON).
SIGNAL
POLARITY *1 MARK*
SPACE Selects the signal polarity mark
or space.
T.O.F.
SETTING
(Top of Form
Setting)
TRACTOR 0.00" to 5.00" (60/180"*)
(0.00 cm to 12.70 cm)
The number increases or
decreases by Vi so"
(about 0.14 mm).
FRICTION 0.00" to 5.00" (60/180"*)
(0.00 cm to 12.70 cm)
The number increases or
decreases by Vi so"
(about 0.14 mm).
CUT SHEET
FEEDER
0.00" to 5.00" (60/180"*)
(0.00 cm to 12.70 cm)
The number increases or
decreases by Vi so"
(about 0.14 mm).
[This setting is operational
when using the optional Cut
Sheet Feeder (KX-P38)].
C
S2.
5'
(D
<D
CO
o
c
■a
GO
3T
* denotes setting when shipped from factory.
*1 displayed only when SERIAL is selected in INTERFACE.
31