Panasonic KX-P3626 - Manual (Page 43)

OMiD® GC
ds
©
s
XJM
Top of Form Function (TOF SET)
This printer has a Top of Form (TOF) function which stores the first print line position and loads the
paper to the designated position automatically. The first print line position will be stored even after the
power is turned off. Additionally, the printer can store 3 different Top of Form positions depending on
the paper feed method [fanfold paper-rear feed { [[| ), fanfold paper-bottom/front feed ( [[T| ) and
single sheets and envelopes-top feed ( Q ) including the optional Cut Sheet Feeder (KX-P38)].
You can adjust the Top of Form position by using the Setup Disk (cs* P. 28-39), or using Micro Line
Feed or Reverse Micro Line Feed within 5" from the top of your paper.
Note:
• Do not rotate the platen knob, otherwise the printer will not be able to count the number of lines.
• When setting TOF for fanfold paper, all adjustments must be made on the first sheet. If you wish
to change the setting after advancing additional sheets you must first park then reload the paper.
I lf necessary, redefine the page length
of the paper you are using through the
Setup Disk ( d ? p . 28-39), control panel
{I®* p. 47-49) or your application
software { P. 52-54).
A page is defined by setting the page length through
the Initial Setup mode (via the Setup Disk or through
the control panel) or the Software command.
Micro Line Feed
Reverse Micro Line Feed
While pressing [ ON LINE ),
press ( LF/FF ].
This advances the paper one micro line (Viso")-
Holding the switches will advance the paper
continuously until you release the switches.
While pressing [ON LINE I.
press I LOAD/PARK I.
This reverses the paper one micro line (Viso").
Holding the switches will reverse the paper
continuously until you release the switches.
The printer cannot reverse the paper past the
printable area.
c
2.
5*
(a
<D
o
o
3
■D
3
(D
At your desired position, release the
switches.
The paper position will be stored automatically as the
new Top of Form position.
43