Panasonic COLOUR TELEVISION CT-32G2 - Manual (Page 15)

R-TUNE
R-Tun© Button
— Pressing O will switch
between the last two channels selected on the numeric
keypad.
Special Functions
Multi Button
CHANNEL NOW
BEING VIEWED
Press Button
CHANNEL TUNED
IMMEDIATELY BEFORE
RECALL
Recall Button -
pressO to review:
0 Audio Mode Status
( 2 ) Channel Caption {Station Identifier)
@ CH Number Or Video Input Selected
@ Sleep Timer Status
Clock Time
(Not used in CT-27G2/U and CT-32G2/U)
The MULTI button can be programmed to operate up
to 6 Remote function buttons at the same time.
For Exampie: TV Power/On, VCR Power/On (selected
brands) can be operated at the same time with one press
of the MULTI button.
Procedure
1. First program the Remote for the selected VCR
Infrared access code. Confirm that the Remote
Control is compatible with the equipment.
2. Face the Remote Control transmitter away from all
equipment remote sensors.
3. Press and hold down the Remote TV Power button,
then press and hold down the MULTI button at the
same time. Release buttons (All previous com­
mands will be erased.)
POWER MULTI
PRESS SIMULTANEOUSLY
4.
o
©
1 ---------- 1
I
STERJgd
IVlDEpj
jSAP I CH3
liicmdl
KXYZ
29 1:00
© ©
©
Cable Power Button
(Not used in CT-27G2/U and CT-32G2/U)
CABLE
POWER
The CD on the Remote Control has been designed
to operate selected brands of Cable Television
Converter boxes. The proper cable television converter
box infrared code must be obtained prior to use. (Please
refer to Programming the Universal Remote for
programming
instructions.) The Remote Control
TV/CABLE switch should be in the CABLE position.
NOTE: The^ or ^ on the Remote may be used for
selecting Cable Converter box channels.
Press a maximum of 6 Function buttons on the
Remote.
Each button you press is equal to one function. If six
Remote button functions are entered, all will register
in the MULTI button memory in the sequence
entered. When less than six Remote button
functions are entered, press the MULTI button to
end the program mode. (Waiting more than 30
seconds without pressing another button will also
end the program mode.)
The following is an example of Remote functions
that can be programmed into the MULTI button.
-
TV Power - For turning TV ON and OFF.
- VCR Power - For turning VCR ON and OFF
(selected brands after programming it’s Infrared
access code, if necessary).
Both can be turned ON or OFF with one press of the
MULTI button.
POWER VCR POWER
MULTI
To delete entered functions - Repeat step 3. Now
you can enter from one to six different Remote
functions.'
NOTE: You can also program the MULTI button to
perform most individual Remote Control button
functions. Buttons which continuously perform a
function as long as pressed (Volume Up/Down,
Channel Up/Down, etc.) cannot be
programmed. Only those buttons which perform
a function when initially pressed (Power On/Off,
Mute, Direct Channel Entry, etc.) can be
programmed.
-
15
-