Remote eontroher wilinot work correctly – Panasonic NV-SD10 Series User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Remote eontroHer wilinot work correctly
SYMPTOM
REMEDY
CHECKED
Remote controller
does not operate
correctly.
Remote controller transmitter
beam is not reaching VTR.
Ensure that remote controller is being pointed at VTR
and that transmitter beam is not obstructed.
Distance is too far.
Use remote controller within 7 m of VTR. If this range
is not possible, replace batteries.
Batteries are exhausted.
Replace batteries by the UM3 or R6 type available
from your dealer. Note precaution for replacement on
page 15.
Batteries are incorrectly fitted
with (+/-) reversed.
Fit batteries correctly as shown on page 15.
Bar code reading is
not possible.
Remote controller is in power
saving condition.
Press SCANNER ON/OFF to turn it on again.
Bar code is not traced
correctly.
Practice tracing the bar code from left to right. Each
bar code should take around half a second to trace. A
beep indicates bar code is read correctiy.
Bar code sensor cap is
blocked.
Remove sensor cap and clean as shown on page 30.
Bar code data
cannot be
transmitted to VTR.
VTR is operating.
Stop VTR.
Timer record memory is full.
Cancel timer programme to enter a new timer
programme or wait until one timer recording has
taken place.
Bar code reading is not
followed by a repeated beep.
Read bar code again.
38