Pilot USA BluLink - Manual (Page 4)

4
Directions
• Insert 2 AA alkaline batteries (panel power version of BluLink does
not require batteries except in “stand alone” mode).
• Plug the cord for headset into headset labeled jack.
• Plug the cord for intercom/panel into airplane labeled jack.
• Connect headset to BluLink.
• Connect BluLink to aircraft panel or intercom system.
• Turn unit on by pushing and holding button for 4 seconds.
Green light will come on and then fade away.
• To turn unit off, press and hold button for 3 seconds until
red light comes on.
• The BluLink is equipped with Auto Shutoff. BluLink will turn
off automatically in 30 minutes when not connected to a
Bluetooth device.
Note: In the battery compartment are 2 switches. The top switch
(A) is a Mono/Stereo switch. If aircraft intercom system is Mono, put
switch in right (2) position. (If you hear from only 1 side of headset, put
switch in right (2) position.)
The bottom switch (B) is for Auto Mute. When the switch is to the
left (1) position BluLink will mute your music source when anyone,
including ATC, speaks over the intercom. When the switch is to the
right (2) position BluLink will not mute the music source.