Softride 26496 Hang5 bike rack (New) - Manual (Page 11)

HANG5 RACK INSTRUCTIONS
27
Return to the six 10mm bolts (1K) on the
Pivot Plates and tighten them up completely
to 30 foot-pounds if bolts were left loose to
align all bolts and holes.
28
Slide Rear Wheel Support Bar (1G) into Smaller
Rear Wheel Support Bar (1H) to make a loop.
29
Bolt the loop onto the Lower Support Bars
using the four 8mm button head bolt set (1M)
(round head with Allen key). Install washer
before installing nut.
*Note: This bolt set has only one washer
per bolt and it belongs on the nut side,
not the bolt head side.
27
28
29
ASSEMBLY OF HANG5 RACK (continued)
Rack Assembly Is Complete. Congratulations, you did it. Next Step: Go Ride!
10mm
bolts
10mm
bolts
11