Softride 26496 Hang5 bike rack (New) - Manual (Page 9)

HANG5 RACK INSTRUCTIONS
21
Carefully align the Vertical Hanger Support
upright until the hole for the Pivot Pin (2K) can
be inserted into place.
19
With the 2 Hole Metal Spacer (2L) in place
insert the top 10 mm bolt through one Pivot Plate
and the Vertical Hanger Support and attach
washer and nut to hand tight.
20
Insert the 3rd 10mm bolt through both Pivot
7SH[LZHUK[OLɫ/VSL4L[HS:WHJLY3
and attach washer and nut.
22
Tighten all three of the 10mm bolts at this time
to 30 foot-pounds.
Tip: If you are sure you will remember to
come back and tighten everything up, you
may leave these three bolts hand tight at
this time. This will allow the remaining bolts
you install to fit into their corresponding
holes more easily.
21
ASSEMBLY OF HANG5 RACK (continued)
23
Repeat steps 16 - 22 on Left Side with
remaining matching set of pivot parts.
20 19
1st
2nd
Pivot Pin (2K)
3rd
9