Tire-SafeGuard TTPM-WWC-SB - Manual (Page 5)

HCI Corporation TTPM-WWC-SB Installation 5
Very Important:
• When installing tire on the
wheel, make sure the tire bead
would not damage the sensor
antenna. When the tire bead is
dropping down onto the wheel
well, If not careful the bead
could break or cut off the
antenna at the root.
• Make sure the sensor antenna
did not get caught on the rim by
the tire bead after the tire was
mounted - it would cause air
leak.
• Keep antenna pointing outward.
2.3 Tractor Antenna & Signal Booster Installation
For tractor there is a cabled antenna for the
steering axle tires. Connect antenna cable to
the receiver via the SMA connector. Lay the
cable under the vehicle body and secure to the
chassis with harness in the location as
showed. The antennas should be aligned with
the center line of the vehicle and placed near
the steer axle from one to two feet. The signal
booster should be installed near the center of
the rear-tire cluster – see next section for
power cord connection instructions.