Verifying the led indicators, Verifying the hardware configuration – Cisco 1805 User Manual
Page 3
6-3
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
OL-14661-01
Chapter 6 Power-Up Procedures for Cisco 1805 DOCSIS Cable Routers
Verifying the LED Indicators
Caution
Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
interpreted as the first command typed when the messages stop, which might cause the router to power
off and start over. It takes a few minutes for the messages to stop.
If the startup messages end with the following lines, the router is ready for initial configuration using
the setup facility (system configuration dialog) or the command-line interface (CLI). Enter yes to
continue with the setup facility; enter no to continue with the CLI.
.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
Note
If the
rommon 1>
prompt appears, your system has booted in ROM monitor mode.
Verifying the LED Indicators
Verify that you have correctly installed the router by checking the LEDs shown in
Verifying the Hardware Configuration
Verify the router hardware configuration by using the following commands:
•
show version—Displays the system hardware version, the installed software version, the names and
sources of configuration files, the boot images, and the amount of installed DRAM and flash
memory.
•
show diag—Lists and displays diagnostic information about the installed controllers and interface
processors.
Table 6-1
LED Indicators
LED
Color
Status
SYS PWR
Green
Router has successfully booted up and the software is functional. Slow,
steady blinking when system is booting or in the ROM monitor.
SYS ACT
Green
Blinking when packets are transmitted or received on any WAN or LAN
interface, or when monitoring system activity.
CF
Blinking
green
Flash memory is busy. Do not remove the CompactFlash memory card
when this light is on.