Initial configuration of the router, Initial configuration, Verifying the initial configuration – Cisco 1805 User Manual
Page 4: Completing the configuration
6-4
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
OL-14661-01
Chapter 6 Power-Up Procedures for Cisco 1805 DOCSIS Cable Routers
Initial Configuration of the Router
Initial Configuration of the Router
This section covers the following topics:
•
Initial Configuration, page 6-4
•
Verifying the Initial Configuration, page 6-4
•
Completing the Configuration, page 6-4
Initial Configuration
You can configure your router by using one of the following tools:
•
Setup command facility—Refer to the
Basic Software Configuration Using the Setup Command
Facility”
section in the
.
•
c Software Configuration Using the Cisco IOS
Command-Line Interface”
section in the
Verifying the Initial Configuration
Verify that the new interfaces are operating correctly by performing the following tests:
•
To verify that the interfaces are operating correctly and that the interfaces and line protocol are in
the correct state—up or down, enter the show interfaces command.
•
To display a summary status of the interfaces configured for IP, enter the show ip interface brief
command.
•
To verify that you configured the correct hostname and password, enter the show configuration
command
When you have completed and verified the initial configuration, your Cisco router is ready to configure
for specific functions. See the
“Completing the Configuration”
section for information about locating
documentation for advanced configuration procedures.
Completing the Configuration
When you have completed and verified the initial configuration, your Cisco router is ready to configure
for specific functions. For advanced configuration procedures, use the CLI.
For configuration procedures using the CLI, refer to the online
. The software configuration documents include information about the following topics:
•
Basic software configuration
•
Feature documentation
•
Troubleshooting and maintenance