Acoustica CD/DVD Label Maker - Manual (Page 76)

If you printed a second test sheet to see how well the printer calibrates with your revised
alignment settings, try the familiar fold-and-measure-the-creases routine again to see if your
changes have improved matters. If you're happy with your adjustments, click the Finish button
to close the wizard and save your changes.
If you decided you don't need to make any changes here, just click the Cancel button to close
the wizard without saving the alignment adjustments you made.
If you want to keep fiddling with your alignment, you can click the Back button to change your
alignment offsets again and reprint the test to see how it works.
If for some reason you want to discard your changes but then apply them later in Acoustica
CD/DVD Label Maker's Printer Alignment dialog, you'll need to know that the Printer Alignment
dialog doesn't deal in negative numbers. Instead, negative offsets on the "Vertical Offset" axis
correspond to the "up" direction on the Printer Alignment dialog and positive offsets
correspond to the "down" direction, while negative offsets on the "Horizontal Offset" axis
correspond to the "left" direction on the Printer Alignment dialog and positive offsets
correspond to the "right" direction.
Printer Calibration Wizard Intro Page
Printer Calibration Wizard Test-Sheet Page
Printer Calibration Wizard Alignment Page
Help Contents
Adjust an Image's Size & Position Dialog
This dialog lets you change the size, position, and aspect-ratio preservation of an image
you've added to a label. All units in this dialog are in millimeters.
You can access this dialog by right-clicking on an image and selecting the "Adjust
Page 76 of 85
6/13/2006 file://C:\acoustica\cdlabelmaker\help\cd-label-maker-flat.htm