Adaptive Technologies 4X4-UD55A-VWD - Manual (Page 10)

© 2013 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-040513
Figure 11
Figure 13
Figure 12
Step 11: Install Second Column Monitors
Starting with the top monitor, connect the power and signal wires to each monitor then align its four M8 adjustable VESA buttons with
the four large slots in the H-slats. Slide the monitor from right to left until it is snug against the left column monitor (Figure 11). Repeat
step 11 for the three lower monitors. Check for front and side alignments-refer to Step 10.
Step 13: Install Third Column Monitors
Repeat step 11 to install the third column monitors.
Step 14: Install Fourth Column Monitors
Lift up the locking arms on the right side of the frame. Starting with the upper
monitor, connect power and signal wires to each monitor then align its four
M8 adjustable VESA buttons with the four large slots in the H-slats. Slide the
monitor from right to left until it is snug against the next column monitor. Pull
down the locking arm to lock monitor into place (Figure 12).
Repeat step 12 for the lower three monitors. Check for front and side
alignments. Refer to Step 10.
Servicing Tips
First (Left) Column Monitor Removal
Reach fingers between the wall and the monitor and lift the locking arm to
unlock. Slide monitor to the left about 1.00” (25.4mm) until its VESA buttons
disengage from the frame, lift a little to support the weight of the monitor then
slowly pull to remove (Figure 13).
Second Column Monitor Removal
Reach fingers between the left-side wall and the monitor to the left of the
monitor being removed. Lift the locking arm to unlock then slide the monitor to
its extreme left position, about 1.5” (40 mm.) Slide the second column monitor
to the left until its VESA buttons disengage from the frame, lift a little to support
the weight of the monitor then slowly pull to remove.
Third Column Monitor Removal
Reach fingers between the right side wall and the monitor to the right of the
monitor being removed. Lift the locking arm to unlock then slide the monitor to
its extreme right position, about 1.5” (40 mm). Slide the third column monitor to
the right until its VESA buttons disengage from the frame, lift a little to support
the weight of the monitor then slowly pull to remove.
Fourth (Right)
Column Monitor
Removal
Reach fingers
between the wall and
the monitor and lift the
locking arm to unlock.
Slide the monitor to
the right until its VESA
buttons disengage
from the frame, lift a
little to support the
weight of the monitor
then slowly pull to
remove (Figure 13).