Adaptive Technologies 4X4-UD55A-VWD - Manual (Page 3)

© 2013 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-040413
Figure 4
Figure 3
Step 6: Install Locking Arm brackets
Assemble the 9-0888 locking arm bracket on three of the 9-0881 left H-slat
and three on the 9-0883 right H-slat near the rectangular slot using the
provided M4 screws, nylon washer and nylock nut (Figure 4). The locking arm
brackets must be installed on the first, third, fifth and seventh horizontal H-
slats starting from the top. Make sure the hook of the locking arm bracket
faces up (Figure 4 & 8). Tighten screw to increase locking arm friction.
Step 7: Assemble the Four Sections of the Frame
Assemble the top left frame by attaching the horizontal H-slats, (9-0881) to the
V-channels (9-0885) using the provided M6x20mm long flat head screws. Do
not tighten screws until all screws are installed. Check for squareness by
measuring corners to corners then tighten screws starting with the screws
on the holes of the H-slats (Figure 5)
Repeat step 7 for assembling the top right frame, lower left frame and lower
right frame (Figure 5). Install the Vertical joiner plate on the upper end v-
channels of the lower frames using M6 flat head screws (Figure 5).
Step 8:
Join the top left frame and the top right frame together using the 9-0806
horizontal joiner plate and 9-0890 center joiner V-Channels (Figure 2 &
6). Tighten screws permanently.
Step 9:
Assemble the bottom left frame and the bottom right frame together
using the 9-0806 horizontal joiner plate and 9-0890 center joiner V-
channels (Figure 2 & 7). Tighten screws permanently.
Step 10:
For wall installation, refer to product installation guide.
Figure 2