Adaptive Technologies 4X4-UD55A-VWD - Manual (Page 2)

© 2013 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-040413
Step 1: Assemble Top Left Frame
Place all of the parts in figure 1A on the floor. Start with
three 9-0885 V-channels with their open side facing up with
the narrow part of the key holes slots facing up and all in the
same direction. Place four 9-0881 Left H-Slats over the V-
channels with the keyhole surface facing up and the four-
hole patterns lining up with that of the channels (Figure 1A).
Rectangular slots in the ends of the slats should be at the
outer edge of the frame. (See figure 3).
Step 2: Assemble Top Right Frame:
Place all of the parts in figure 1B on the floor. Start with
three 9-0885 V-channels with their open side facing up with
the narrow part of the key holes slots facing up and all in the
same direction. Place four 9-0883 Right H-Slats over the V-
channels with the keyhole surface facing up and the four-
hole patterns lining up with that of the channels (Figure 1B).
Rectangular slots in the ends of the slats should be at the
outer edge of the frame. (See figure 3).
Step 3: Assemble Bottom Left Frame:
Place all of the parts in figure 1C on the floor. Start
with three 9-0885 V-channels with their open side
facing up with the narrow part of the key holes slots
facing up and all in the same direction. Place three 9-
0881 H-Slats, one 9-893 bottom side H-slat and one 9-
0895 bottom center H-Slat over the V-channels with
the keyhole surface facing up and the four-hole
patterns lining up with that of the channels. Place
three 9-0897 vertical joiner plates at the top of the V-
channels as shown in Figure 1C. Rectangular slots in
the ends of the slats should be at the outer edge of the
frame. (See figure 3).
Step 4: Assemble Bottom Right Frame
Place all of the parts in figure 1D on the floor. Start with three 9-0885 V-channels
with their open side facing up with the narrow part of the key holes slots facing up
and all in the same direction. Place three 9-0883 Right H-Slats, one 9-0893
bottom side H-slat and one 9-0895 bottom center H-Slat over the V-channel with
the horizontal keyholes facing up. Place three 9-0897 vertical joiner plates at the
top of the V-channels (Figure 1D). Rectangular slots in the ends of the slats
should be at the outer edge of the frame. (See figure 3).
Step 5: Assemble Center Joiner Assemblies:
Place one 9-0890 center v-channels on the floor, each with their opening facing
up and with the narrow end of the keyhole slots facing up. Place four each 9-0806
Horizontal Joiner plates with thread side down over the 9-0890 center v-channel
as in Figure 1E and Figure 2.
Bottom Left Frame (Figure 1C)
Bottom Right Frame (Figure 1D)
Figure 1E (Center Joiner Assembly)