ALFA NETWORK AIPC933D - Manual (Page 11)

Network Camera User’s Guide
11/91
Hardware Installation
1. Use the provided L-wrench, loosen the tamper-resistant housing cover (with screws
still attached on the cover). The unit has a factory installed side conduit entry and one
may adjust the cables to back conduit entry according to installation requirement.
2. Set the mounting base onto the wall or ceiling and center it over the mounting hole, using
the supplied four retaining screws to secure the main body.
3. Set the proper image by moving the camera body (some model may be limited by the
PCB board to180°rotational adjustment) and set the focus by turning the lens to the left
or right direction.
4. When the camera focus adjustment has been completed, use the provided L-wrench
to fasten the tamper-resistant housing to the main body.
5. Once the picture appears on the monitor, open the cover and adjust the lens wrench
to “TELE←→WIDE” of the lens, get the view zoom that you desire, and then adjust the