ALFA NETWORK AIPC933D - Manual (Page 39)

Network Camera User’s Guide
39/91
White Balance:
Auto: will adjust the white balance automatically.
Hold: will hold the white balance.
Exposure Control:
Auto: will adjust the exposure automatically.
Hold: will hold the exposure setting.
Maximum Exposure Time:
User can limit the maximum exposure time of the image sensor. The larger value means
longer exposure time possibly.
Color Level:
Large value will be colorful.
Brightness:
Large value will brighten camera.
Sharpness:
Large value will sharpen camera.
Contrast:
Large value will contrast camera heavily.
De-Noise:
De-Noise can remove or lower unwanted noise and preserve fine details and edges.
Default Settings:
Restore to factory image settings.
PTZ Setting
Camera Protocol:
This device can connect to a PTZ camera or speed dome camera and controls them thru
RS485 interface.
Camera Address:
This is the camera ID set in PTZ camera or speed dome camera. Note that please DO
NOT change the default value if unnecessary. If so, user needs to check and set value
properly for both sides.
Baud rate:
This is the communication speed between network module and P/T scanner.
Note
If need to change these parameters, user needs to check and set value properly
for both, network module and P/T scanner.